Question: Do Subs Smell When Breaking In?

How long does it take for a subwoofer to break in?

0:30 So, the first thing you need to do is run extremely low bass through the subwoofer at moderate volume for about 15 to 20 minutes.

Ease into it.

Let the poor thing get warmed up and cycling.

Don’t try and take a subwoofer out of the box, any manufacturers, and turn it right up to 10..

How do I know if my sub is blown?

If the cone is rigid or locked in place, the subwoofer is definitely blown. Even if the cone moves, listen for scratching noises and be sensitive to any movements that are too loose or sluggish, as they may all be signs of a worn suspension.

Do subs need to be broken in?

A common question is if JL Audio speakers or subwoofers require a break in period. The answer is no. While it is true that the suspension of a speaker will loosen up over time, there is no need to play a speaker at half power or low volumes for an extended period in order to aid or ease into this.

Is it better to overpower or Underpower a subwoofer?

It’s better to overpower a speaker than to underpower it — the distortion caused when you push a low-powered amp or receiver to its limit is much more likely to harm a speaker than too much power.

What hits harder 2ohm or 4ohm?

A subwoofer with a lower electrical resistance produces a louder sound than one with a high electrical resistance, which means that 2ohm subwoofers are louder than 4ohm ones. Although louder, 2 ohm subwoofers are also more likely to produce a poorer quality of sound due to its’ power consumption.

Do 10s hit harder than 12s?

10+ year member 10s don’t hit harder than 12s.

What’s a subsonic filter on an amp?

A subsonic filter is a component on your subwoofer that reduces the intensity of notes which come through at lower frequencies. It decreases the amplitude of those low notes that you feel more than you hear.

Why does my subwoofer smell like burnt rubber when it plays?

What you smell burning is the glue securing the voice coil wires in one place. Depending on how much damage there is, the sub may stop making the burning smell and play fine. Or it may just stop working one day.

What happens if you don’t break your subwoofer?

What can happen if you skip breaking in your subs? If you don’t allow for a break in period you could run into one of the issues below: Burned or unwound coil: Burned or unwound coils can be caused by the buildup of excess heat and a distorted signal. Stiff spiders leave you with less suspension travel or excursion.

Is it bad to play subs in the cold?

Be very careful when playing your subs in very cold weather. I’ve seen cones and surrounds crack even without being turned up too loud. The cold is very bad for plastic because it makes it so stiff,the same goes for surrounds being made out of foam or rubber or even a blend of the two .

Why do new subwoofers smell?

New subs can get a little stinky if you get at them, there’s often bits of excess glue burning off. … There is only one reason that subs smell and that is because the voice coil glue is getting hot and ‘off-gassing’. This is the only reason subs smell bad.

How do you break in a brand new subwoofer?

If the sub is already installed in the vehicle and mounted in an enclosure, simply turn your subsonic filter up to around 40 Hz for the first week or 12 hours of playtime. … The other method we commonly recommend is breaking a subwoofer in free air.

Do subwoofers get louder as they break in?

Subwoofers should not get louder as they break-in. Instead, they will adjust to the varying frequencies provided and will most effectively play the sounds that are coming through.

What is better 2ohm or 4ohm subwoofers?

The kind of resistance that the sub has will determine the loudness and quality of bass you’ll get. … Basically, a 2 ohm subwoofer demands less power from the amp and tends to deliver louder bass. On the contrary, a 4 ohm subwoofer will demand more power from the amp and deliver less loud but higher quality bass.

Do speakers have break in period?

After about 100 hours of use, your speakers should be broken in. The speaker surround and spider materials loosen up the more the speaker is used. Not all speakers will sound dramatically different after break-in. Some improve only marginally, while others can change dramatically.